Fanuc Spindle Amplifier Alarm 29

Fanuc 6055, 6063, 6064 digital spindle amplifiers
Fanuc 6072, 6078, 6082, 6088, 6102 amps
Fanuc 6111, 6112, 6116, 6141, 6142 amps

An excessive load (standard setting: load meter reading of 9 V) has been applied continuously for a certain period (standard setting: 30 seconds).

1. If this alarm is issued during cutting check the load meter, and review the cutting condition.
2. If this alarm is issued during a stop
   1. The spindle is locked. Check the sequence to see if the spindle is locked when a command for very slow movement is specified or orientation is specified for the spindle.
3. If the spindle does not rotate as specified (the spindle rotates at a very low speed) and this alarm is issued.
   1. The setting of a parameter is incorrect.
   2. The phase sequence of the motor power line is incorrect.
   3. The feedback cable of the motor has a problem. Check if the phase A/B signals are connected correctly.
   4. The feedback cable of the motor is faulty. Rotate the motor manually to see if a speed is indicated in the item of motor speed on the CNC diagnosis screen or on the spindle check board. If no speed indication is provided, replace the cable or spindle sensor (or motor).
4. If the spindle does not rotate as specified (the spindle does not route at all) and this alarm is issued
   1. The power line is abnormal. Check if the motor power line is connected normally. If the spindle switching or output switching is performed, check if the magnetic contactor is on.
   2. The SPM is faulty. Replace the SPM.